Acu Rite Thermometer 00591W User Manual

INSTRUCTION MANUAL  
BATTERY INSTALLATION:  
For the first installation, insert batteries in the main unit first, then  
the remote sensor.  
Wireless Thermometer with Sensor  
Model 00591W  
1. Insert 2 AAA Alkaline batteries into the main unit.  
2. Insert 2 AAA Alkaline batteries into the remote sensor.  
Acu-Rite instruments have been designed and engineered to  
provide accurate and reliable measurements. Please read the  
instructions thoroughly before setting up the wireless thermometer.  
Low Battery Indicator:  
Low battery indication is shown on the LCD of the main unit. To  
replace the batteries, follow the set-up procedure as mentioned in  
thermometer set-up.  
For desktop display, lift out the foldable stand located on the back  
of the main unit and sensor. For wall mounting, use the hanging  
slot by fastening with a nail or screw.  
The main unit and the remote sensor have an approximate battery  
life of 12 months. (Alkaline batteries are recommended).  
Name & function of buttons:  
Main Unit:  
Max  
Min  
Clear  
Press to read maximum memory  
Press to read minimum memory  
Clear memory  
THERMOMETER SET-UP:  
Place batteries in the main unit first.  
Lift off the rear cover of the remote sensor by separating  
front and back panels at the side seam.  
Remote Sensor:  
Place batteries in the sensor and press “TX” button to  
send a signal to the main unit. Select temperature display  
at this time by pressing the “C/ F” button.  
C/ F  
TX  
Select C & F  
Transmit temperature  
Replace back cover on sensor.  
Main unit:  
The wireless thermometer with display indoor temperature  
after installing batteries.  
(Replacing Batteries)  
The remote temperature will be displayed after installing  
batteries into the remote sensor.  
When replacing batteries in the remote sensor, reset the main unit  
by removing and installing batteries. Follow thermometer set-up  
procedure as outlined.  
Remote sensor:  
C/ F  
TX  
Select C & F mode display  
Manually Transmit Temperature.  
MIN/MAX/MEMORY:  
High and low temperatures can be recalled by using this feature.  
Intended for outdoor use. Maybe used indoors. Will  
display temperature of immediate location.  
The sensors can transmit up to 100 feet distance in open  
area.  
The sensor unit has a weather-resistant case.  
When replacing batteries for the remote sensor, remember  
to clear the corresponding channel of the home unit by  
removing the batteries.  
When replacing batteries for the home receiver, please  
remove batteries of remote sensor and re-install the  
batteries to the sensor. Press the TX button and replace  
the cover.  
Press MAX button to read maximum temperature memory  
Press MIN button to read minimum temperature memory  
To clear the memory record, press clear one time.  
TROUBLESHOOTING:  
The main unit may flash the outdoor temp display if outside  
interference is occurring. Most of the time the unit will re-sync on  
its own, or by bringing the sensor closer to the main unit. However,  
if this should continue to occur, the following may also be the  
reason:  
A. Low battery indicator.  
B. The sensor has been placed outside of the effective  
transmission range (more than 100 feet).  
C. Sensor may have outside interference that is preventing  
proper transmission (metal surfaces, electrical devices,  
etc). The sensor may need to be moved if interference  
continues.  
Note: The “TX” and the “C/F” are hidden inside the  
protective backing to ensure weather resistance of this  
unit that is intended for the outdoors.  
The remote sensors are not “waterproof” meaning able to  
submerse, but rather water resistant or weather resistant.  
Prolonged exposure to cold weather may cause damage to  
the LCD panel and in addition can drain your batteries.  
Extreme heat can cause your batteries to drain and more  
importantly, explode and corrode in the compartment.  
Battery corrosion will harm the unit.  
LIMITED WARRANTY: Should this product from the Chaney Instrument  
Co. prove to be defective in material or workmanship within one year of  
original purchase it will be repaired or replaced. This warranty does not  
cover damage in shipment or failure caused by tampering, carelessness, or  
abuse.  
Although these units are intended for outdoor use, placing  
them in a protected area will preserve the life of the unit.  
591IN1  
CHANEY INSTRUMENT CO.  
LAKE GENEVA, WISCONSIN 53147  
Main unit temperature range: 32°F to 122°F  
Remote sensor: -4 °F to 130°F  
 

ACCO Brands Laminator H520 User Manual
Aiwa Stereo System NSX D70 User Manual
Akai Electronic Keyboard MPK mini User Manual
Allied Telesis Switch AlliedWare Plus User Manual
Alpha ToolComHK Limited Dust Collector ECOGRDGR User Manual
Amana Cooktop AKT3020 User Manual
American Audio DJ Equipment 250HP User Manual
American Dryer Clothes Dryer AD 120ES User Manual
BC Speakers Speaker System 6 XT 13 User Manual
Behringer DJ Equipment KX1200 User Manual