Eureka Tents Tent 08 User Manual

ASSEMBLY INSTRUCTIONS  
FOR THE ASSAULT OUTFITTER:  
7. Connect the six  
side-release buckles on the  
fly to their mates on the tent  
webs. See fig.7.  
Component List:  
1 Tent Body, 1 Fly, 3 Pre-bent Tent Poles, 1 Carry Bag,  
1 Stake Bag w/Stakes, 1 Pole Bag,  
8. At the rear of the tent, stake  
down the pull-out web on  
the fly.  
NOTE: Do not drop tent bag or pole bag on its end. Do not bounce tent bag on  
its end to get the tent out. These actions may cut the shock cord and/or  
damage the pole ends.  
Fig.7  
9. At the front of the tent, pull the vestibule taut and stake it  
down. Make sure that the vestibule is tight across the door flap.  
With the vestibule staked down and tight, go to the corners /  
sides of the tent and adjust the web pull-outs to tighten. Then if  
necessary, adjust the rear vestibule stake out loop. See Fig.8.  
1. Unpack the tent bag and separate the components. Unfold the tent  
and lay it out with the floor on the ground and with a grommeted web  
in each corner. Pull the tent into a rough rectangle. Do not stake down  
the tent just yet; but in windy conditions, stake down one corner that  
faces into the wind.  
Fig4  
2. Assemble the three shockcorded tent poles. Carefully seat each  
section. Try to keep the poles from snapping together as this can  
damage the rod ends.  
5. Your tent is now free-standing; place it in the desired location  
and use the metal skewers to stake it down.  
3. At the front of the tent body at A, slide a pole diagonally across the  
tent, through the sleeves, to the opposite side B. Follow the seam  
from sleeve to sleeve. Push the pole, don't pull it. Continue with the  
second pole through its sleeves from C to D. Finish with the third pole  
6. With the tent secure, unroll the fly and drape it over the tent.  
The fly only fits one way; make sure the vestibule panel  
window is directly over the front door of the tent. Reach under  
See fig.1.  
from E to F.  
®
the fly and connect the Velcro fasteners to the tent poles,  
through the openings in the sleeves. See figs.5 & 6.  
B
D
E
F
Fig.8  
Fig.1  
C
A
Your tent is now ready for use.  
NOTE:  
• The vestibule door of the fly can be rolled up at the bottom,  
4. Insert the post end of a pole into its grommet on the corner  
up to the top or to the side for better ventilation. Attach the  
stake-out web. See fig.2. At the opposite corner, grasp the web  
and simultaneously push the pole to form an arc. Insert the post  
into the grommet to maintain tension. See fig.3.Repeat with the  
remaining poles, raising the tent. See fig.4.  
toggle to hold in place.  
the doors open.  
To help prevent condensation, keep  
Fig.5  
• In strong winds, tie extra ropes to the storm loops on the fly  
and stake down.  
®
Take down : Pull up stakes. Release the fly's Velcro and  
buckles. Remove fly and open door. Pull posts out of the  
grommets and push poles out of the sleeves. Collapse the  
tent poles and stow. Fold the tent onto itself and fold the fly  
and lay it on tent. Roll up both towards the door and stow.  
Fig.2  
Fig.3  
Fig.6  
REV.C 4.09  
 

3Com Network Card FEM656C User Manual
Adesso Tablet Accessory WKB 2000CD User Manual
AEG Cooktop FM 4803K AN User Manual
Aiwa Speaker System AWP ZX7 User Manual
Aiwa Stereo System xr m55k User Manual
American DJ Music Pedal FSR 800 User Manual
American Standard Hot Tub SPS 2774E User Manual
Audiovox Automobile Alarm PRO 9675FT User Manual
Audiovox Remote Starter 128 7853 User Manual
Barco Projection Television R9002930 User Manual